Hello, Here is a guide to help you see what you are in for when doing the job with diagrams below of the camshaft sensor location for both engines.https://www.chathamtownfc.net/articles/camshaft-angle-sensor-replacement

*

Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.Cheers


You are watching: 2001 jeep cherokee crank position sensor location

*


Have a 2002 jeep grand cherokee 4.0L when starting it just cranks first 2 trys when starting then turns over 0n 3rd try-runs great after it starts, where is crankshaft sensor located on this eng. And is it difficult repair
*

Check fuel pump and fuel pressure crank sensor by the rear at the bellhousing

*



Other Category problem2001 Jeep Cherokee Engine Size unknown Four Wheel Drive Automatic 60,000 mile can not find where this litlle item is located if you could give me an exact location it would greatly be appreciated
Its on the left side of the transmission bellhousing see below.

*

Is there anything else I can help you with?
Hey MikeWhen I post this reply my monitor flashes then it opens then here you are-Wow! Kind of freaky. For some reason were hitting the same subject at the same time. Sometimes I win and sometimes I lose.Drink 1 for me will you-its nite time there for it.
Engine Mechanical problem2001 Jeep Cherokee V8 Four Wheel Drive Automatic 102.00 miles01 grand cherokee 4.7 v-8 where is it located
My 1999 did the same thing and the sensor is in an impossible spot to fix on the bottom of motor above the transmission. I was told that if the vehicle isn"t acting up don"t fix it. Somewhat of a dummy light.
Where is the crankshaft positioning sensor on the 2000 cherokee 4.0 engine? Do you have to pull the starter to change it?
It"s in a horrible spot and it"s a common Dumby check engine readout. If the car runs good don"t replace it


See more: Temperature M I Wanna Be The Papa You Can Be The Mom, Temperature Misheard Lyrics

Noises problem1999 Jeep Cherokee 6 cyl Two Wheel Drive Automatic My 99 jeep grand cherokee dies if it goes below 1000 rpms and if it goes above 2000 rpm it constantly jerks. Also the oil pressure gauge is not working properly at times it will fluctuate between 20-40 but most times it stays near 0. My ex husband just recently replaced both the ignition coil and the crank shaft sensor unit in the last 3 months. A mechanic friend told me to get in the jeep and turn the ignition key on then off and then on and off and then on and watch for anything to pop up such as the check engine light flashing and count the flashes I did try this but what I got from the dash controls was where the mileage is this appeared "P 0352 P 1391 done" done this mean anything and what is the best thing to do. Also today the trans over temp light came on and the overdrive off light came on. Once I turned the vehicle off for a while and restarted it this went off.