Hello, I'm Danny.Here is the info you requested. This is a tutorial for you to check out on exactly how to change a fuel filter:https://www.chathamtownfc.net/articles/how-to-change-a-fuel-filterI've attached photo steps below for friend on just how to remove and replace the fuel filter on your vehicle. Hope this helps and thanks for making use of chathamtownfc.net.


You are watching: 2001 buick lesabre fuel filter location

*

*

*

*

*

ns am trying to replace the fuel filter on mine 2001 Buick LeSabre. First, whereby is that exaclty? Secondly, is it essential to remove any kind of fuses in the fuse box prior to removing the old fuel filter? I review somewhere that this is an extremely important. Other areas online, however, do not even point out this. Many thanks for the help.


See more: How Many Gallons Does A Semi Hold ? How Much Gas Does A Tanker Truck Hold

Fuel filter is top top the frame, listed below vehicle, just forward the the gas tank, an installed in fuel line. Disconnect the an adverse battery cable (MUCH better than remove fuse) relax the fuel mechanism pressure. Twisted the rapid connector 1 / 4 turn in every direction to loosen any dirt that might have gathered in the connector. Use compressed air come remove any kind of dirt in the connector. To express the plastic tabs the the masculine connector and also pull apart. Remove threaded connection from the filter inlet. Eliminate the filter. Come install: place the fuel filter, making sure it is dealing with in the suitable direction. Attach the outlet quick connect line come the fuel filter as follows: action 1: Be sure the connector is clean and that a brand-new plastic retainer is provided on the filter. Action 2: use a pair of fall of engine oil to the male pipe end of filter. Action 3: press the fuel heat onto the fuel filter till the plastic retainer snaps right into place. Step 4: inspect that the connector is locked right into place by make the efforts to pull the connector from the filter. Install the threaded connection to the inlet next of filter and tighten to 22 ft. Lbs. (30 Nm). Connect the negative battery cable. Pressurize the fuel mechanism by turning the ignition switch to the ON position for 2 seconds. Turn OFF the ignition switch because that 10 seconds. Revolve ON the ignition switch. Inspect for fuel leaks.